7600X Curve Optimizer: -30 all-core is fine in games but dies in single-thread Cinebench — back off or go per-core?

cheap_frame
New member
Posts: 6
Joined: Sun Oct 04, 2026 6:18 pm

7600X Curve Optimizer: -30 all-core is fine in games but dies in single-thread Cinebench — back off or go per-core?

Post by cheap_frame »

Been running my 7600X at -30 all-core for about three weeks. Games are fine, Handbrake is fine, even a 30-minute Cinebench multi run is fine. Temperatures dropped like 8C and it holds boost better.

Then last night I ran Cinebench in single-thread mode just to see the score and it hard-locked within 40 seconds. Rebooted, ran it again, locked again. Dropped to -20 all-core, single-thread passed but my multi score went back to roughly stock.

So now I'm stuck between "-30 is obviously unstable, just run -20" and "-30 is fine except on one core at max boost, so tune per-core instead." Anyone actually gotten a stable per-core map out of a 7600X, or is this one of those things where the best core is the problem and per-core just means one core at -15 and the rest at -30?

Top