RX 7800 XT undervolt + dual monitors: idle still sits at ~40 W, and per-state tuning doesn't touch it — what actually fixes this?

BinnedQueued
Member
Posts: 13
Joined: Fri Oct 23, 2026 8:18 pm

RX 7800 XT undervolt + dual monitors: idle still sits at ~40 W, and per-state tuning doesn't touch it — what actually fixes this?

Post by BinnedQueued »

Been running a 7800 XT for a few months now and finally got around to a proper undervolt. Settled on 1030 mV on the top state with a small clock bump, and it's been rock solid in everything I throw at it — power in games dropped something like 30 W for basically no fps loss.

Problem is idle. I'm on two monitors, main is 1440p 165 Hz over DP and the second is an old 1080p 60 Hz panel on HDMI. When nothing's happening, Adrenalin still reports 35–45 W board power and the memory clock just sits pinned near max. Fans don't spin up or anything, but my office gets warm and it's just wasted power.

I tried messing with the per-state tuning in Adrenalin and it does nothing for idle. Is the undervolt even relevant here, or is this purely a display thing? Do I need to match refresh rates, or am I stuck with it?

Top

KernelDrops
Member
Posts: 11
Joined: Fri Oct 02, 2026 3:18 pm

Re: RX 7800 XT undervolt + dual monitors: idle still sits at ~40 W, and per-state tuning doesn't touch it — what actually fixes this?

Post by KernelDrops »

Yeah, per-state tuning won't help you at all here. The voltage table only really matters in the upper states — idle is state 0/1 and the memory clock is the thing that decides your wattage down there, not core voltage.

Mismatched refresh rates are the usual suspect. 165 Hz + 60 Hz is basically the textbook case. I had the same thing on a 6700 XT and dropping the second panel to 60 Hz and setting both in Windows to the same refresh fixed most of it. Not all of it, but most.

Also double-check you're not running browser hardware acceleration on a paused 4K video in a background tab. That alone keeps my card out of its lowest state.

Top

MoboWhisper
New member
Posts: 7
Joined: Sun Sep 27, 2026 2:18 pm

Re: RX 7800 XT undervolt + dual monitors: idle still sits at ~40 W, and per-state tuning doesn't touch it — what actually fixes this?

Post by MoboWhisper »

KernelDrops is right, and it's worth being precise about why so you don't waste an evening on it.

Adrenalin's per-state tuning (Tuning → Custom → the voltage/frequency table) maps to the GPU's DPM states. Your top state is basically state 4/5, and that's what a game or a stress test loads. Idle is state 0, which on RDNA3 is governed by the display engine and the memory clock, not by the V/F curve you edited. So a 1030 mV top-state setting is genuinely useful — it's cutting your gaming power and heat — but it will show exactly zero change in idle draw. That part isn't broken, it's just out of scope.

The 35–45 W idle is almost certainly the memory clock refusing to drop. Verify before changing anything: leave the machine on the desktop for five minutes with nothing open, then look at the memory clock and "GPU only power draw" sensors in GPU-Z or HWiNFO. If the memory clock is pinned near its maximum instead of dropping to a couple hundred MHz, you've confirmed it. The cause is usually the display pipeline needing a fixed memory clock to drive two outputs whose timings don't share a common blanking interval — 165 Hz and 60 Hz don't.

Practical order of attack:

  • Set both monitors to the same refresh in Windows. Even 120/120 usually drops you into double digits.
  • If that's not acceptable, try the second panel at 60 Hz from a DP port rather than HDMI; mixed outputs are worse than two of the same.
  • Check for HDR on one display and not the other, and any custom resolution you've created — both keep the memory clock up.
  • Disable hardware acceleration in your browser and chat apps temporarily to rule them out.
  • Measure again. On a properly configured dual-display setup you should land somewhere around 12–18 W at the wall for the card alone.

One caveat: some of this is driver-side and has improved and regressed across releases, so don't chase it with a VBIOS flash. If matching refresh rates gets you to ~15 W, take the win and stop there.

Top

BinnedQueued
Member
Posts: 13
Joined: Fri Oct 23, 2026 8:18 pm

Re: RX 7800 XT undervolt + dual monitors: idle still sits at ~40 W, and per-state tuning doesn't touch it — what actually fixes this?

Post by BinnedQueued »

Alright, that lines up with what I was seeing — I checked and the memory clock is basically pegged at max while sitting on the desktop, so it's not the voltage table at all. Bit annoying that Adrenalin lets you edit the whole table and then the low states are effectively decorative, but fair enough.

I'll try matching the second panel to 120 Hz and see what the sensors say. Honestly if it lands under 20 W I'm happy, the gaming undervolt is doing the heavy lifting anyway.

Top

midrange_mack
Member
Posts: 17
Joined: Sun Oct 18, 2026 12:18 pm

Re: RX 7800 XT undervolt + dual monitors: idle still sits at ~40 W, and per-state tuning doesn't touch it — what actually fixes this?

Post by midrange_mack »

Same boat, 7800 XT + a 144 Hz ultrawide and a vertical 60 Hz side panel. Dropping the side panel to 60 Hz did nothing for me, but matching both at 120 Hz took idle from about 38 W down to 16 W. Weirdly the 144 Hz on both was worse than 120 on both, so don't assume lower is always better — test a couple of combos.

Also worth pulling the second monitor cable entirely for a minute just to get a baseline number. Costs nothing and tells you whether you're chasing a display issue or something else running in the background.

Top